Can I find out the output impedance of my amp?


I called Art Audio a while back, but I'm not convinced they knew based on the serial number I provided. I would like to make sure it is at 8 ohms. Is there any (simple) way I can find out myself? Can I put a multi meter somewhere in the loop?
markpao
Hi Mark,

I strongly suspect that the output impedance of the amplifier is NOT 8 ohms, and that the "Output Impedance: 4 and 8 ohm" specifications given at the Art Audio site are actually (and confusingly) referring to the speaker impedances that the output taps are designed to work into. The output impedance of the amplifier will usually be considerably different than the load impedance it is optimized to work into.

And if, as I suspect, what you are trying to accomplish is to verify that the output tap has not been customized to work into a load that differs from 8 ohms, a measurement of the amplifier's actual output impedance won't help, at least without being analyzed in the context of a schematic and other detailed design information.

You might try contacting Art Audio UK, and asking them.

FWIW, though, the one method that occurs to me of accurately measuring the amplifier's actual output impedance is to play a test tone into, for example, an 8 ohm high power resistor, then playing the same tone at the same volume control setting into say a 4 ohm high power resistor, and measuring the voltage that appears across the resistor in each case. The output impedance of the amplifier could be calculated from the amount by which the voltage decreases as the load impedance decreases. While the measurement would have to be done on only one channel, to avoid possible damage to the amplifier BOTH channels should be loaded, either with a resistor or with a speaker.

Best regards,
-- Al
Al,

"And if, as I suspect, what you are trying to accomplish is to verify that the output tap has not been customized to work into a load that differs from 8 ohms,..."

Yes, you are correct. Not even sure how it left the distributor when new.
Thanks for your suggestion. I actually think I can handle that. I have an email into Art Audio UK, I'll first see what they say.
I don't know of any output taps that are exactly as stated. VTL/Manley set their output impedance to 6 ohms so their amplifiers would be compatible with either 4 or 8 ohm speakers.