If Preamp Gain is Set to High-What Consequences?

If I was not clear in my original post, the internal gain setting was set by a Joule technician to its highest setting (measured at 15db). The gain control on the front (the volume control) is what I can turn up 25-30% on 2 of my sources and up to 40% on my other sources before the speakers get too loud.

You are confusing the 'gain' of your pre-amp and the strength of the signal from the source. The gain of your pre-amp line stage as seen by your amp is constant 15v (?). Your volume control does not change this.

The strength of the signal from your source varies, but for example CD sources typically average about 2v but can vary from 1v to 6v.

Now the part misunderstood by many.....The volume control on your pre-amp does not change the 'gain' from your pre-amp's gain (line stage) section it controls (attenuates) the strength of the signal from your source. So when you rotate the VC you are reducing the strength of the signal from the source.

Hope that is clear. Anyway, no problem. What you describe is normal.

Thanks for the information Newbee, but I'm not confusing anything. The gain of the Joule can be set internally from lower to higher by changing the position of jumpers on a circuit board. The Joule technician set "gain select" at the highest setting, a measured 15db. This leaves me with much less play in the volume control (Joule calls it "gain" on the faceplate). I'm wondering if the gain-select jumpers had been set to a lower setting and I had more play in the volume control than I currently have, if that would improve the sonics or make no difference. For example if I had the ability to turn the voulume as high as the 50% point rather than being limited to 25-40%.