Zavato, there are actually 2 "soundstages" involved, 1) the soundstage of the recording and 2) the other one that is independently projected by your system. If the system's soundstage is less than optimal, then the presentation of the recording soundstage is in some way limited or curtailed accordingly. Typically and, in particular, it's curtailed in terms of things like its overall size shape and dimensionality, depth-vs-width ratio, its ability to disappear from the speakers, forward envelopement, coherence, air, distances between performers and so on. All these things can be impacted by speaker positioning, xover quality, the relative quality of component power supplies, amp/preamp design, wiring and much more. Ideally, the point of a hifi is to "allow" (and I'm stressing that concept as much as possible) the soundstage that the recording engineers labored to create to come through to the listening room (via your system) as unaltered or as unimpeded as is practicable. In other words, hopefully and as much as possible, the recorded soundstage should 'fit cleanly within' the system's soundstage without the system acting to impose its own soundstage limitations onto that of the recording. For most of us, all that can be easier said than done, at least to start with...and I haven't even yet mentioned the complication presented by the acoustics of the room itself. I can tell you from direct experience though, that once all that's done, the recorded soundstage is very typically much larger than the zone between the speakers. In my setup there is very often as much information from about 4-5 feet outside edges of the speaker cabinets as there is between them. This is not "added" by sound engineers. Many folks do not realize how much their own system may be actively convoluting, or distorting, the soundtage of their recordings and, as a result, may from time to time infrequently experience 'random' or 'unexpected' musical sounds from outside the edges of their speakers, but without it appearing to be commonplace or otherwise natural sounding and believably a part of the presentation. The typical conclusion is that some recordings are in some way 'manipulated' to achieve this effect, but it plainly isn't so. Nor is it necessary. Good systems can allow either the entire, or the majority of, the recording's soundstage to come through well enough for everything to be properly coherent. I have a roughly $5k CD-only rig, but have coupled it to almost $6k of power conditioning. I'll be the first to tell you that's just a wee bit unorthodox, but in my case it has worked wonders without drawback, but on that, of course, YMMV. My components, while not state-of-art highend, are, like yours, not "poorly designed" either. But, the kind of conditioning I found not only kills electrical noise (the real enemy), but also makes bad power supplies sound acceptable, and acceptable ones sound good, good ones sound excellent and excellent ones sound off the hook. In the end, soundstage may be, at least somewhat of a degree of distortion - one that may be necessary to complete the audio illusion (at the very least, no 2 systems have the same inherent soundstage fingerprint), but, to that degree, I welcome it. But, I'm saying really the biggest challenge is undertaking the pursuit of not 'cramping its style' as much as possible. Regards. John
