Infocus X1 projector to Outlaw Audio 975

Have you tried contacting Outlaw audio themselves? They have pretty good customer service and support. I'm sure someone there can be of assistance.

Thanks for all of the responses. I went out and got a TV with HDMI inputs so I could access the Outlaw on screen display (apparently, this is the only way to do this is via HDMI). So, I adjusted the TV and Video sources from HDMI to component in the hopes of getting the projector to recognize the processor. Still no luck. I'll go back and try to adjust the upscaling from 1080p to 1080i to see if that helps, as someone already suggested here. Will let you know. Keep your fingers crossed.....

If using the component video output on the Outlaw,
you must use the component video inputs only (p20 - Outlaw manual).
Also, if you are using the Integra DPS-6.7, its resolution must be set to 480p to get an output from the component video outputs (p58 - Integra manual).

Thanks for all of the responses. I went out and got a TV with HDMI inputs so I could access the Outlaw on screen display (apparently, this is the only way to do this is via HDMI). So, I adjusted the TV and Video sources from HDMI to component in the hopes of getting the projector to recognize the processor. Still no luck. I'll go back and try to adjust the upscaling from 1080p to 1080i to see if that helps, as someone already suggested here. Will let you know. Keep your fingers crossed.....

Still no luck. I am getting audio to work now, but no video. I adjusted the Outlaw to 1080i from 1080p. Even tried dumping down to 720 and 480p. Nothing. I also tried switching to Native.
The source I'm using is a DVD player via HDMI connection. Perhaps HDMI is not going to show up through a projector connected via component? If that's the case, then the only good solution would be to get a projector with HDMI, right? Yikes, more $.