do i still need a pre-amp


time to upgrade my older pioneer elite rear projection tv to a plasma. everything now requires HDMI so my old rotel pre-amp cannot be used.

i have aerial speakers, martin logan sub, rotel amp and a panasonic blue-ray player.

i only use this setup for tv and movie watching so i was thinking to save some money just using the source switching on the tv as a pre-amp.

any thoughts if this would cause a loss i sound quality or ??

thanks
18sdrras
keep your rotel preamp; connect your cable box and bluray by hdmi directly to your tv (for video) and also connect red/white rca from cable box and bluray to your preamp for audio.
What LoomisJohnson suggested will work provided that you have cable and that your cable box has analog outputs. If you are receiving your signal over the air and your TV is doing the decoding then the suggestion will not work.

Very few if any TVs today have analog audio outputs, only optical. The signal being output by the TV will be Dolby Digital stereo or surround depending on the broadcast. If this is your case, then you are going to need a processor with an optical input to convert the Dolby Digital Signal to analog stereo.
thanks .. My cable is wired and has digital out as does my DVD player and my rotel has two digital inputs so if I understand correctly ...
HDMI from cable to TV
HDMI from DVD to TV
Digital from Cable to Rotel
Digital from DVD to Rotel

So to watch TV, I use the source control on the TV and for sound the processor?

thanks
It sounds right to me. I guess that answers your question, you still need a preamp.