Scraping sound

Zd542, my advise was to check the main platter bearing for grease, not the tonearm's unipivot spike bearing. The later has no grease.

String... Both the OP and I own the Zephyr. The OP's concern related to his Zephyr. My post is about my Delos, which seems to also produce a groove scrapping sound.

Your comment suggested that I lift the back-end of the Delos. I asked whether this is the optimal way to mount the Delos because I recall reading that the Delos should be mounted parallel to platter.

So to sum it up, both the OP and I are talking about similar problems, but different cartridges. I did, However, mention that my Zephyr is on its way to SS for an inspection and re-tip of necessary.

Follow up Q: my Delos does not produce a scrapping sound on all records -- just some. If the stylus was worn or schoozted-up, would the scrapping sound always be present? It might seem that it would??? In any case, as soon as my Zephyr comes back from SS, the next "patient" will be the Delos for an inspection.

Bill_K,

After I typed out my response, I looked at your reply again and thought I may have read your post wrong. I don't see how the platter bearing could cause a scraping noise like the OP describes. (I'm not saying you are wrong. I may be overlooking something.) On my VPI's, there's no grease but they do have a light coating of oil. I find that if I don't clean it, things like dust and lint stick to it. The design of the arm is so sensitive, I thought a little dust may knock the cart out of alignment.

The back of the cartridge is scraping the record.
The arm is a VPI JMW 9t.

Any suggestions about the best way to remedy this?

Thanks