Attaching a power bar to my power conditioner

Sorry I guess I didn't give you enough details
I will try to answer your questions above in sequence

Yes it is a single duplex to the wall unit
I have the conditioner powered into the wall as well as the seperate power supply for my pre amp (i've tried plugging this directly into the wall and it sounded very bright)

I don't have dedicated lines 15 amps regular circuit
I have my Cdp and amp plugged into the PLC
There are 2 digitally filtered outlets 2 analog outlets and one amp outlet on the blue Circle

The amp is an 80 watt hybrid from Blue Circle bc 24
The blue circle conditioner capacity is 1200 watts
I am pondering a new amp upgrade and this amp will have 225 watts this could change things

Mike,

Good show!

I think your MR 2000 should be sufficient for your whole system, even if you go to a bigger amp. Use it as indicated.

Meaning, plug the CDP into one of the digitally filtered oulets (the other one can be used just fine for an analog device -- try your preamp PS on that one, it could benefit from some digital noise filtering)

Plug the amp into the amp outlet on the PLS.

If you have noise or hum on the system after connecting it this way, try lifting the AC plug grounds (using cheater plugs) of all components but the preamp. Do the amp first, then (only if necessary) the CDP. Keep the PLC grounded of course.

It's nice to be able to plug a power amp right into the wall, if it can be on its own circuit, etc. But in your (electrical) situation, I'd advise you to run everything through the PLC. It has plenty of capacity for your equipment requirements not to be restricting dynamics. If you feel dynamics are being restricted by the amp being run thru the PLC, it's easy enough to find out by plugging the amp into the unused receptacle (still with the ground pin lifted.)

Thank-you !

I appreciate your help

Cheers