TECH GURU's out there, how to clean Circuit Board?

well, 1st unplug from the wall. ensure that the power supply caps are discharged before you stick your hand inside the chassis.
best would be if you can disassemble the portion of the amp that needs cleaning. this way you can conveniently handle the PCB outside the chassis.
use alcohol - the 90% type you can get at a drug store - to clean the mess.
Chemtronix makes a can of a fluid called "Flux-Off" that is water soluble. You can spray this on the PCB & then remove the residue w/ alcohol.
Hooe that this helps.

Thank you very much, the Chemtronis and the Alcohol,they wont damaga the board correct? I am thinking I can remove any parts from the board so I might use a small brush and dip and clean kind a thing, would that work?

Thank you

Rapogee

If it aint broke ......

I would take the lid off, go outside and use a can of compressed air to blast off the excess dust and hair. The only reason I would do this is to ensure good air circulation inside the amp and prevent fires. IF you're very careful you could use a vacuum cleaner.

I would not clean the PCB, certainly not with 90% alcohol (the other 10% is water). If the PCB is working then it doesn't need cleaning.