Built a Flexi-type rack?

As I recall, the final cost of materials was right around $550 - a simple breakdown was $275 for the maple (sourced from a local millworking company), another $125 for the brass audiopoints, and around $150 or so for the brass bits from McMaster-Carr. A similar rack from Mapleshade is right around $1000 + shipping. The basic differences are in upright diameter (1.25" steel on the Mapleshade vs. my .75" brass ), and in the shelf dimensions, where I use a 24" x 24" shelf, the Mapleshade uses a more "standard" rectangular audio size of 24" x 15". I also dispensed with the Amish craftsmen ;-))

-Richard

Thanks Richard,
I got a price from McMaster website:
Brass rods 3'-$47x4= $188
6'-$77x4= $308
They don't have 4' length listed

Brass nuts and washers- appr. $150
Plus maple.
You obviously didn't pay much for 4 shelves in that size.
A guy of Timbernation that sells maple blocks on A-gon would charge $720 for 4 18x24x2 shelves.
Are you in Pennsylvania or NJ? If you could share a source of the maple, it would be greatly appreciated.
Ilia

Ilia-
If you want to consider alternatives in shelving materials for a DIY rack, I would suggest you look at http://www.johnboos.com
You can get "BoosBlocks" from them in an 24 x 18 x 1 1/2 dimensions for as little as 60.00 each. They are made from 100% eastern rock maple, and work very well with brass rods, nusts and washers from McMaster-Carr. I have built several of them in two and three shelf versions and they can be seen on my virtual system page. A three shelf model I built came in at under 300.00 for parts, until I had Lloyd Walker custom machine a set of Valid Points and Discs for the bottom...
BoosBlocks can also be purchased from Williams-Sonoma and Sur L'Table.

Thank you Slipknot,
I'll look into butcher blocks option.

I would like to point out that I constructed this rack about three years ago. With the wild upward fluctuations on the world metals market, I am not at all suprised by the price quotes on the raw material. Material such as copper has nearly doubled in price over the past 4 years, and wood seems to rise continuously in price. Last night, I dug up the invoice for the brass - $178.44 (so I was off by $25), but still this is indicative of how much the price has risen over the past few years. BTW, my invoice shows $31.14 each for the threaded rod - a considerable increase to $47 each!! I'm in Albany NY, and actually sourced the material through a millworking company outside of Utica. I'd recommend them, but since I'm trying to be helpful, won't - since they were a pain to deal with. Nice product, but it took forever to complete. Cheers,

-Richard