Built a Flexi-type rack?

Maril555 is right; the beauty of the threaded rod is the ability to level anything anywhere. Looking at Jamestown's pricing, it will cost you no more than $12 and no more than 1" of space on the bottom shelf to simply level that bottom shelf on its own with four extra nuts.

Getting those extra nuts will also save a lot of time...and it will keep the whole rack more versatile since the wood might warp a little. The ultimate goal in my mind is to get the components that are on the shelves level, which is what I always use as a reference. My 2" and 4" cherry shelves ended up not as flat after two or three years as they were when they were new. They are not butcher block though, they were very BIG boards originally [like 12” x 2” I think].

The 1" rod does pose an issue with the points. However, you could always rifle drill and tap into the end for a simple 1/4-20 thread and put stock Mapleshade or audio points on them.

I have a set of solid 1.25" brass rods that I will be using for my new rack. A local machine shop cut them to length, truing each end of each rod, rifle drilled and tapped all three rods, then cut the excess material into 6 - .75"x 1.25” spacers that are also all drilled and tapped. All this for the whopping grand total of...$40 cash.

My guess is that having any of these rods drilled and tapped for 1/4-20 thread would be very easy and reasonable. Plus...you'd have more options as to what to use for the points/feet.

Leveling a rack of this type can only be done by varying the depth the threaded rods are threaded into the cones at the bottom. Example: all rods should be the same length, so, on a level floor, the last nuts on top would all be threaded evenly onto the rods so that the rods are flush with the top nuts. If however, the floor is not level, then the threaded cones at the bottom of the rack would be unscrewed until level was achieved, this way, the top of the rods would still be even in the top nuts. A jam nut would have to be used on the bottom cones for this purpose.

Or use Acorn nuts on the top to hide the rod's end.

Mijknarf - Nice rack BTW [stereo rack]

I just heard back from Jamestown Distributors, they have changed vendors for the brass all-thread rods and can no longer honor orders at the old pricing. The new price is now $75 per 3' rod! I re-ordered through McMaster at $45 per...
Dang!

Gordus: I just had the same experience with Jamestown. Guess I dallied too long. The price of brass (which may well continue to rise, I'm told) makes this a more than budget project, for sure; I just spent about $160 @ McMaster Carr for the nuts and washers alone (!). John