2. tech-talk
  3. 1182646644

Soldering 101 for Audiophiles

I am replacing the tweeters in my Tympanis with new ribbons which I have just received from Magnepan.

Unscrewing all of the screws, it seems they are connected at the top and the bottom with a soldered connection?

I have a cheapo pencil shaped soldering iron from Radio Shack around the garage but otherwise havent soldered anything since I tried to put together a Hafler amplifier in 1979 and ended up paying someone else to do it.

Can anyone please explain:

* basic soldering technique
* what materials do I need for the best audiophile connnecton? Silver?

Thank you,
cwlondon
eldartford
4,262 posts
 
In general one should not rely on solder for mechanical strength. Crimp the wire to the terminal, and then add solder.

Plumbing soldering is a bit different, and probably as much a skill as electronic soldering. Of course you don't heat the solder, but you don't heat the pipe either. Only apply heat to the fitting, and the solder will be drawn into the connection when the pipe gets hot enough for solder applied at the joint to melt.
ohlala
1,236 posts
 
There a lot of good sources for hifi oriented soldering basics online which are more elaborate than the fine advice here. Finding them via google is very easy, which is perhaps what Herman had in mind.
pauly
1,012 posts
 
Get a nice soldering iron also. Spending $150 on a Weller would be well worth it considering how much easier it is to use than an el-cheapo and the cost of your speakers.

Regards
Paul
herman
2,266 posts
 
My point is simple.

Can anyone please explain:

* basic soldering technique

Millions of words have been written on this and can easily be found on-line. There is nothing "audiophile" about it.
eldartford
4,262 posts
 
Herman...Audiophiles can make ANYTHING into a mystical art... even solder.
More to discover