Aluminum in cld plinth

Mrjstark
I am planning layers of 3/4" birch plywood and mdf, and am wondering if sandwiching some aluminum would be of any benefit, as I have the 1/8th sheet for free.

Jtwrace
I dont have the cnc machines to cut this but I an sure I have the connections. I would want to know it is worth it, if I were to call those favors. I can cut the thin sheet myself with stuff I own.
As always thanks for your ideas and knowledge!

I am hardly an expert, actually very far from it.
Some TT designs use aluminium as a plinth material.
However sandwich is kind of new to me and might or might not be beneficial. It is hard to tell, at least from my point of view. I am working right now on the plinth for my Lenco. Materials used are premium MDF 3/4 inch and Baltic Plywood which is better then Birch in my opinion (13 layers in 1 sheet ). This plinth is my second one, so my experience is very limited. My first one is made from Bamboo BB, walnut for arm board and Mahogany motor stand.
I also didn't find a lot of support but took a chance and it worked just great. Bamboo BB is about 10 times harder then maple BB and it sounds GOOD (I don't want to put to much sugar in your tea - but it sounds GREAT ). What I'm trying to say try it - my advice, make it heavy (40-60 pounds ). You can also incorporate a dedicated TT stand & platform for even better performance.
I would only recommend that you use top & bottom layers out of Ply. or MDF + separate arm board(s).
Keep us informed on the progress and your final design.
Good luck on your project.
Mariusz

I would not think that the aluminum sandwich would be of any benefit. It don't think that it would hurt. It might add a little weight so that could be the only benefit I think. Try it!!! That's part of the game....

I am planning 6 layers of alternate ply and mdf. i was also going to make a 2 or 3 layer platform and use 3 spikes on the bottom of the tt, and platform.

"I would only recommend that you use top & bottom layers out of Ply. or MDF + separate arm board(s)."
Mariusz, can you elaborate here,i am a little slow to get the picture.

thanks

I don't know the details of your design or what TT it is based on. But I would used Ply. or MDF for top & bottom from practical point of view, could be easier to work with on finale details and mounting hardware and such. It may also be a little safer approach ( using aluminium/MDF/Ply. together for the first time ). MDF is a good material for the arm board so is Ply or solid wood. I simply don't have enough knowledge or experience to predict the effect of the 1/8inch aluminium sheet on the arm/cart. I would just play safe for now and if it worked in this project you can always try it next time (top, bottom - Alum.).