slew rate and rise time


Hi, can anyone explain to me the difference between slew rate and rise time? Thanks in advance.

Chris
dazzdax
(http://www.amplifier.cd/Tutorial/Slew_Rate/SlewRate.htm) (http://electronics.wikia.com/wiki/Amplifier#Bandwidth_and_rise_time) Click on, "bandwidth and risetime" second site. They are very similar, but not identical. These two threads should give you some insights.
Chris - slew rate is a slope of the signal going up or down expressed in V/us (rate of change). Rise time is only for known amount of volts going up (fall time for going down).

We use slew rate when voltage doesn't have any particular range of interest (output of an amp etc.) and we just want to know how fast is it changing. Another case might be when something depends, by definition, only on the rate of change - like transmission line effect.

Rise time and fall time are used mostly when voltage range is already defined like 5V logic or 3.3V logic etc.

Slew rate (as well as rise or fall time) can be applied to any analog quantity like current, resistance, light etc.
Rise time is defined as the time it takes a signal to go from 10 percent of it's peak value to 90 percent of its peak value. For example, if you have a 0 to 10 volt pulse, the rise time is the time it takes for the pulse to go from 1 volt to 9 volts. For a 0 top 5 volt pulse, rise time is the time it takes the pulse to go from 0.5 volts to 4.5 volts. Fall time is similiarly defined, but in the other direction. Rise and fall times are just that, time measurements specified by a single unit. Slew rate is a units per time (eg. volts per time) measurement, specified with two units; eg. volts / time.

Slew rate is typically used to describe an amplifier (look at a spec sheet for an op amp). Rise and fall times are typically used describe signals.