2. tech-talk
  3. 1236832030

Dedicated Lines - Sub panel or no?

Hi folks,

In a few months time I will be moving to a new home, where a spare bedroom and an understanding wife will enable me to enjoy the luxury of a dedicated listening room.

The first thing that comes to mind is installing 4 dedicated 20A lines. The breaker panel is on the ground floor, the room is on the 3rd.

I'm wondering which is better:

-to run all four lines from the breaker box all the way to the wall outlets,

-or install a sub-panel (is that the right term?) in the room, and use a single, very heavy guage line from the breaker box to the subpanel, then run 4 short lengths of 10 or 12 gauge from the subpanel to the outlets.

Thanks in advance for your advice

Kind Regards
Mick
128x128mickey_sg
ngjockey
1,042 posts
 
For more fun, I got lower amp draw, compared to unloaded, on the primary side when I had just a little secondary draw.
hevac1
812 posts
 
I am trying to find A transformer I can switch on and off. I am in the trade but it is taking a while to locate. A UPS could work but the last one I tried did not sound good.
I too had GFI outlets. Mine will be in the basement about 20' away.
ngjockey
1,042 posts
 
Transformers are like motors in that they can take 3 times the current at start-up. Maybe oversize the breaker and use a 3 phase starter with overloads. I've been installing Telemanique's recently because of the price and simplicity.

BTW, found the term for draw under no load is called "exciting current".
emailists
923 posts
 
Wow, what a great thread. I can't do any of things suggested here due to being a renter, and not sure even how long I'LL be in my current location. But I'm looking to buy an apartment within the next 18 months, and at that point can really investigate an serious power delivery system.

For now I'm lucky I have found in our new place 1 dedicated 20 amp line with only 1 outlet wired to it. (I switched it to Oyaide R1)

When I am an owner, I would also like to try opening the wiring connections to the breaker box, and the breaker connections to the bus themselves, clean them with Progold and coat them very lightly with Quicksilver Gold.

I use Quicksilver on the in wall 10 gauge wire before inserting the wire into the Wall outlet, and when making extension cords, gang boxes, etc.

I can't compare the benefits of using Quicksilver on the power connections, but on the internal connections of an output section of an amplifier, I heard significant improvements after using Quicksilver.
hevac1
812 posts
 
Ngjockey,
I tryed the a started also at the time. The starter held just the breaker still tripped, it was a 50 amp breaker. I think I will have to try fuses. I can get fuses that will hold at 8 times the inrush. Costly they will be. I am also thinking of putting on a Line Reactor, it will slow down and or eliminate other issue with electrical power. I use then i my trade to stop unwanted noise from going into or out of a VFD.
More to discover