Copper Sleeve over IEC


There has been several threads on AA about putting a 1 1/2" copper union (coupler) over the IEC on the CD Player, Preamp, Amp.

Well I tried it...

Anyone else give it a try?
128x128ozzy
For those ordering I decided to take a Watt gate / marinco IEC and AC plug end to my nearby Ace hardware... Warning NOT ALL THE copper fittings are going to fit, Problem is that ONLY the fittings with a 1.25" ID(Inner Diameter)will work, most of them have a 1.25" OD (outer diameter)

All of the straight fittings I found had only a 1.25" outer diameter so they did not fit over the body of the plug, the 1.5" are WAY too big and you would need to fill the gap with a bunch of tape or something to beef up the connectors size and or Tape it on in place if you don't want it falling off. The best I found was a Coupler made with one end as a 1.25" inner diameter, and it was then reduced to a 1.25" outer diameterÂ… And use a pipe cutter to just cut it at the rounded reducer shoulder and throw the bad half away.. This fits super snug and has a professional finish.
Thanks for the info. The largest plugs I have,(and they are pretty large),allow the 1 1/2" copper couplers to go over it. It does'nt fall off either on the IEC or the AC end.

I suppose if you had a real big AC plug with a very thin cable, then you would need something to hold it on. One of the posters suggestions was to use some sticky back foam insulation on the cable before sliding the copper sleeve over.But anyway you get there is good.

Can you post or send a picture of your finished product?
If you need to expand the coupler take it to muffler shop and have it expanded a bit..... They didn't charge me to do mine.
Bombaywalla-man,

I LOVE your Scintillas !!

Try McMaster Carr or cruz to a local hardware store if you strike out
at Home Dumbpot or Lowesly.

Take your P/C with you and gage it on the spot, that's what I did.
You can skip the double sided tape and just use a bead of Blu tack on each side of the Body and it will slip on tight and the blu tack will just ball up underneath and keep it super solid without vibration.. also this way it is removable with a little force to slide it back off, that is if you have the correct 1.25" ID copper pipe to finish it well without it just hanging off rattling around like on that marantz video.