Yes, I'd go several coats, rubbed hard with four ought steel wool, followed by soft rag, final coat with soft rag. I rushed my table, and the wood is underprotected. The brass will patina if not treated. Not sure what to use, though.
Audio Rack Construction
Happy New Year All!
I'm planning a rack with three wood (maple) shelves using threaded rod as the supports. This will be something similar to Salamander racks. Besides, the metal washers and nuts, I'm going to be using some type of isolation washer that will contact the top and bottom of each shelf.
So...shelf, isoloation washer, metal washer, and then nut.
Questions: 1. When passing the threaded rod through each shelf, should the holes in the shelves not allow the threaded rod to touch, so the only thing touching the shelves are the isolation washers? 2. Besides neoprene, what's a good material for the isolation washers? 3. After leveling each shelf during assembly, I'm planning to add aluminum tubing over the threaded rod and nuts between each shelf for a cleaner look. This would mean that the top and bottom ends of the aluminum tubing would also contact the shelves. Should I avoid this, or additionally add some isolation material between the ends of the tubes and the shelves?
I'm planning a rack with three wood (maple) shelves using threaded rod as the supports. This will be something similar to Salamander racks. Besides, the metal washers and nuts, I'm going to be using some type of isolation washer that will contact the top and bottom of each shelf.
So...shelf, isoloation washer, metal washer, and then nut.
Questions: 1. When passing the threaded rod through each shelf, should the holes in the shelves not allow the threaded rod to touch, so the only thing touching the shelves are the isolation washers? 2. Besides neoprene, what's a good material for the isolation washers? 3. After leveling each shelf during assembly, I'm planning to add aluminum tubing over the threaded rod and nuts between each shelf for a cleaner look. This would mean that the top and bottom ends of the aluminum tubing would also contact the shelves. Should I avoid this, or additionally add some isolation material between the ends of the tubes and the shelves?
- ...
- 49 posts total
Thanks, I just rubbed the oil in with a cloth. I'm in Colorado where it's pretty dry, so I better look into the steel wool. The worst part of this project, is cleaning the brass rods that I got from McMasters. I spent about twenty five minutes last night on one rod and I'm still not quite done. I did the two-stage dishwasher soap/Brasso cleaning that produced many blackened rags. Makes me want to seal the rods instead of letting them oxidize again. For me, it's always most difficult to finish those final details, but I am looking forward to the assembly. The only negative I see with the nitrocellulose based laquer is that it's highly flamable as it's a relative of dynamite. Windows open, turn off the electric heat...and it's winter! |
Finally finished the FlexiRack! I'm very happy with the way this project turned out. Thanks everyone for your help and suggestions. Here's a picture...no surprise that it looks like others in the forum. http://cgim.audiogon.com/i/vs/i/f/1265411095.jpg |
- 49 posts total