In many elderly systems, pre WWII, they ran a wire from the neg terminal, on the driver, to the plated metal basket. This is a ground plane for the driver, there is no particular control over the materials affecting the electrostatic moments in the AC signal, but it has to be better than what is available in your wall, out in the yard and down the road to the substation. Not that service should be by passed in any way, but an alternate is advised, at least for the speaker.
I would absolutely NOT connect the speaker ground to the house system ground, under any circumstances. You are almost certain to form a ground loop antenna and many new and unusual sounds might be the result.
If you want to experiment with a loop of wire, use lamp cord, about 2 feet of it. split it into two halves, strip the ends of each piece and twist them together, making a shorted turn of wire. Connect this to your speaker,s black lug. This will not provide you with a carefully controlled set up like Ground Control does, but you should find some quite noticeable differences in performance.
Bud
I would absolutely NOT connect the speaker ground to the house system ground, under any circumstances. You are almost certain to form a ground loop antenna and many new and unusual sounds might be the result.
If you want to experiment with a loop of wire, use lamp cord, about 2 feet of it. split it into two halves, strip the ends of each piece and twist them together, making a shorted turn of wire. Connect this to your speaker,s black lug. This will not provide you with a carefully controlled set up like Ground Control does, but you should find some quite noticeable differences in performance.
Bud