amplifier power consumption

Just to further Almarg's & Jea48's point re. ensuring that you buy a UPS with a true sinewave output - I understand that some friends bought an UPS that did not (i.e. output a sq. wave) & they were not aware of this & it fried the electronics over a short period of a few months.
So, be very careful of the output waveform. Most of the time UPSs are targeted to PCs that use switching power supplies hence it does not matter but to audio electronics sq. waves are bad news. APC has come out w/ an audio version UPS but I believe that it's not cheap.

Your best bet would be to buy a PS Audio unit OR a (Canadian) PurePower unit. The PurePower has a battery backup while I believe that The PS Audio units do not.

Rrog, my amp has been modified and puts out more power than it did in its original state, but i will look on the back of the amp anyway (hadn't actually thought to do that! duh!)

Riley - thank you very much - I may just go out and pick up one of those!

Almarg and Jea48 - I appreciate your advice as well (and will pay heed to your warning about the unit not measuring peaks).

by the way -

Stangely, a very good service technician whom i know suggested using even the CHEAPEST one by a company called APC (the unit that puts out 200w). He states that he has all his equipment (all tubes) ALL connected to it (amp, cd player, tt) and that it 'does the same job as the more expensive ones', therefore 'you don't need anything more'. I asked him several times if he's sure... and he insisted it was more than fine for my application.

His statements really confused me, to be honest, since it doesn't seem to make all that much sense to me. Then again, i'm not an electronics technician.

"The largest your budget allows. Even though the watts may be sufficient to run your amp, dynamics can still suffer."

I agree with Face. Amp that consumes peak 600W, like mentioned Cambridge, does not take 5A sinewave current but short narrow pulses of very high current (repeated 120Hz).

Strangely, a very good service technician whom i know suggested using even the CHEAPEST one by a company called APC (the unit that puts out 200w).

That is probably this model, at $49.99.

I believe that when ac power is present all it does is to pass the incoming ac to the devices that are plugged into it, with some degree of surge suppression applied to the ac. One of the documents indicates a total current capability for all of its outlets of 8 amps, when ac is present.

When ac power drops out, or drops to too low a level, the battery backup kicks in after a delay of a few milliseconds. That provides a stepped approximation to a sine wave, which will keep a 200W load powered for about a minute.

So for several reasons (lack of true sine wave in backup mode; lack of power regeneration; completely inadequate power rating in backup mode; and noise filtering which is probably either ineffective or not provided at all) you don't want to let that get anywhere near your audio system. :)

APC's much more expensive products that are intended for audio and video systems, which I understand to be generally highly regarded, are linked to here. And here (on the lower half of the page) are some comments by Kal Rubinson on their model S15.

Regards,
-- Al