How many dedicated lines are enough?


Until a day ago I thought two dedicated lines with 30 amp breakers, 10 guage solid core Romex was all I needed, plus a couple of Shunyata power conditioners and power cords and a few HiFI supreme fuses.

I isolate my Depth sub and Audio Aero cd player on a separate dedicated line with both plugged into a Hydra two.

The turntable, Pre/phono nand tiny 2 watt power amp were plugged into a Hydra 8 on the other line,same phase of the panel of course.

Just for something to try ,I set up a third dedicated line ,this time with a 20 amp breaker, same Romex for my 2 watt power amp.
The amp has a HiFi Supreme fuse and old vintage RCA rectifier, but other than that it's stock.The amp uses a Shunyata Annaconda Helix power cord and it's plugged into a Shunyata Venom recptacle at the end of the dedicated line.

The results were more than positive, perhaps just getting the amp out of the power conditioner, hydra 8 was the answer.I used to think the amp sounded better in the Hydra 2,but since we're only dealing with 2 watts I didn't think that there would be much difference, so my plan was to filter and isolate the CD player the way that I did and plug the amp into the Hydra 8, keeping it all analog.

I am curious if others have had similar results using numerous dedicated lines and further isolating the components?

So far for me,the cd player needs to be on it's own line,then the amp, and then a third line for everythingelse seems to be the best solution.

I did try everything plugged into the Hydra 8 on one dedicated line and didn't like it .
lacee
I found each component I have likes it's own dedicated line. So when I built my room I installed over 20 direct lines. Each of my 4 Krell amps is a little pig and hate to share a line with each other or any other component. Likewise each digital component has its own digital line until recently when I started using PS Audio's P 10. I now plug all my digital into this. In my view you can't have too many.
Like Sgr, I built my room with dedicated lines, each marked as phase one or phase two. Fourteen are 120 volt and two are 240 volt.

Ten of the 14 are phase one and four are phase two. Phase one is the (slightly) higher leg that runs the analog. The slightly lower voltage leg is for digital. (121.5v versus 119.7v)
Like money, you never have enough. However, the best formula I have seen is your age time two. Yes, each year adds the need for more, and that assumes you are getting wealthier and buying more gear.
I have three lines also.

The first for my digital equipment, (CD player, CD recorder and SACD Player).

The second for my preamp and turntable.

The third for my amplifiers.

(That seemed to be the minimum number based upon my research at the time I had them installed.)

My two cents worth anyway.
more is always better =). unfortunately my electrician blew me away with the estimate for what i wanted. retrofitting my 50 year old house's basement with the 8 dedicated lines i had hoped for was a budget buster (new panel box and tearing up almost all the walls). ended up getting 2 installed fairly inexpensively at $800. use one for HT and the other for 2 channel. added a psa quintet to keep things as isolated as possible. i definitely noticed a difference even with two.

would have liked eight but ended up with two. still very happy.