Can a variac be used to maintain constant voltage?

What you read is correct. For a given setting, an ordinary Variac will provide an output voltage that is proportional to input voltage.

There are some Variac-like devices, such as this one, which regulate output voltage by using a motor to automatically vary the setting as the input voltage changes. When the motor runs, however, this particular series of regulators, and I would imagine others that are like it, makes far too much noise to be usable near an audio system.

Regards,
-- Al

There are also Constant Voltage Transformers based on transformer saturation effect http://www.lenco-elect.com/constant_voltage.htm

The problem with them is poor efficiency and often some distortions of the sinewave.

Even if your voltage changes by 10%, your amp has, most likely some form of feedback making it regulated. Only max peaks will be affected and only if voltage drops. Lets assume drop of 10% making drop in available (peak) power of 20% it will change perceived loudness only by 5%. Just set your loudness not higher than 95% (to prevent clipping) and regulation will take care of the rest. Preamps, CDPs etc are all regulated.
Perceived loudness = k^(1/3.5) where k is ratio of powers.

Regulator will make it worse, in my opinion, since amplifier's supply current is in form of narrow spikes of high amplitude causing voltage drops - unless you use greatly oversized transformer or device that provides line AND load regulation.

So, if an ordinary variac does not maintain voltage at its fixed setting, what is the purpose of using such a variac, i.e. is it simply to revive an old amp from storage for instance by slowly increasing the voltage to nominal levels?

That would be good application. They also bring supply voltage to regulation range of electronics in case of wide variations (constantly too low or too high).