x-tronic 4000 soldering station

Kijanki - thank you a lot for the response.
No surface mount work, at least for now, may be later, I am considering playing with capacitors in my CJ PV-12.
I guess you are correct that having the 180C lower iron limit is not practical since it will take a long time to solder as you said. I was gonna use the WBT 4% Ag.
But for now I need to wire the arm, do it a couple of times with different wires, Audio-Note silver arm wire, also C37 litz wire. Some other speakers wiring work as well.
So I was told the soldering station (I do have a very simple radio shack solder iron) will play better since I would be able to ajust the temperature easily. The heat gun could be used for shrinking the colored sleeves onto the cartridge clips.

Avs9, Hot air gun might be usefull for shrink tubing. I use standard large Wagner heat gun but smaller hot air gun or hot air pencil might be easier to use. If you plan to use different solders (different melting temp) then perhaps you need soldering iron with adjustable temperature (changing tips is less convenient). Look for at least 40W power. When your soldering station has adjustable air flow and temperature for hot air gun/pencil it will be useful in future for surface mount.

Hakko is well known but most likely more expensive. X-tronics looks like a very good bargain especially with magnifying glass lamp. I found model 4040 here for amazing $140 http://www.amazon.com/X-TRONIC-MODEL-4040-Soldering-MAGNIFYING/dp/B003TC8EQS

I also found review: http://www.youtube.com/watch?v=oC30-GUbgk4 You might want to find second part of it. His soldering of capacitor requires perhaps one second longer to make solder flow into the hole. I usually solder about another 2 seconds from the moment of melting.

If you are using WBT 0800(4% Ag); the melting point is 178/180 degrees C, according to my spool's label. No problems, at all, soldering at just slightly above that temp. If the lower limit of a soldering station is 180 degrees, so what? You can always increase the temp.

Rodman99999, You should not solder at 180degC. Proper temperature is 370degC otherwise fluxes evaporate and new oxidation will appear (takes too long). Higher temperature is not only to melt solder quickly but to heat up soldered leads, PCB etc. - otherwise solder doesn't "flow". Some Weller soldering Irons use Curie effect to regulate temperature. Standard tip is set at 700degF.

Like I said, I've been soldering at slightly above the temp on the WBT 0800 spool, without any problems. I would not have bothered commenting, but for the fact that the OP is using the same solder. These guys recommend 250 degrees C, as the ideal temp: (http://www.takefiveaudio.com/PDF/WBT%200800.PDF) That's very close to what I'm reaching, with excellent flow, and the halogen-free flux does a fine job. Have you ever used WBT's lead-bearing/4% silver solder?