2. tech-talk
  3. 1367883047

Tweak you gotta try. Post your results...

Well I read some reviews about the new High Fidelity cables that were designed by the former owner of Virtual Dynamics. They seem to be using magnets as their claim to fame in their design.

I happened to have some rod type axially magnets that were about 3/8" in diameter and about 1" long. I installed 2 of them near the end of my speaker cables near the speakers. 2 sets are needed for each speaker wire left and right).They are installed so that the magnetism is pulling through the cable.

It is quite interesting, but I would like some others to try this and share their opinions before I comment.

I also added a set at the Amp end.These magnets cost about $3.39 each and you will need at least 4 of them or 8 if you want to try them also at the Amp end.

I bought mine from http://www.amazingmagnets.com/show-fractional-r1000c.aspx

Make sure you select USPS for about $4.95 shipping otherwise you will end up paying for UPS at about $13 for shipping.
128x128ozzy
csontos
1,311 posts
 
Enter Edward Leedskalnin. If anyone had a handle on the secrets of magnetism, it was him.

Here's a good 'Leed' for you Geoff. You may just come up with something but it'll probably take a little effort on your part. I expect 10% off the top:)
geoffkait's avatar
geoffkait
23,365 posts
 
I get a lot of my colored magnets from Leeds, already. Different guy. Lol. One of my favorites is their little yellow magnet, the one for the door jamb. Blue for anything steel, red for aluminum. Heh heh
csontos
1,311 posts
 
Heh heh is right. Wouldn't it be more fun though, not to have to laugh? Everything has it's place, however.
marakanetz's avatar
marakanetz
5,473 posts
 
did anyone try to use fridge magnets on amp chassis or other components? they're much cheaper and in some cases free.
csontos
1,311 posts
 
Now there's an idea, Geoff. Just post a note. Again, 10%.
More to discover