Post-Katrina salvage of audio gear and software

Sorry for your loss. I can't imagine the feelings going through your head about the past and the uncertain future.

Doubtful that even the chassis of the electronics would be salvageable.

Most of us probably don't carry enough insurance to cover all of our stuff in such a catastrophy.

I bought some jazz records that had been in a flood a few years ago, many cleaned up. The hard part was getting the mold to release. The paper sleeves are abrasive, so moving them without cleaning first will be tough. Best of luck.
Deb

I am sorry to hear of your miss fortune. This is indeed devastating. First off I wish you and yours the best and hope that as a country we can rebuild this area into something special like it once was.
As for the gear, I am not a professional in the audio business but just a Hifi buff. IMHO I think the wires will be no good as well as they are not waterproof and will oxidize over time. I would not take the chance of hooking them up to anything you may value in the future as the moisture may create electrical shorting. Laissez les bon temps rouller

Hello David!

Great to hear you and your parents and Trixie made it out okay. I feared the worst for your house, and from what you describe that seems to be the case. I'm still kind of shell-shocked by it all, and I wasn't even there.

Regarding the post-flood prognosis for your equipment, my suggestion would be to give Richard a call. I'm e-mailing you his cell phone number through your Audiogon identity; I lost your e-mail address. If you can't get your e-mail that's sent through Audiogon for some reason, then e-mail me at audiokinesis@yahoo.com.

Your vinyl might well be salvageable. I'm thinking a good soaking in a mild detergent solution to loosen the paper as the first step. Alan T. might be a good resource on this, but I don't have his contact information either. Richard might. Anyway, you'll probaby have some mildew in the grooves, and Kevin Blair of Buggtussel sells a record-cleaning enzyme that is supposed to work especially well on mold and mildew. I'll put on my dealer hat and give him a holler. Here's a link to his mold-eating enzyme page:

http://www.buggtussel.com/vinylzyme.asp

If you want to call me, my New Orleans-based cell phone isn't working reliably yet but you can reach me at (208) 852-2610.

Lori also says hello.

Duke

Hello David,

First, my thoughts and prayers are with you and all those about you!

It may be a long shot, but the electronics may be salvageable. I'm not too sure, but since the components are air tight then they should be water tight also. Dismantle as much as possible and flush out all the silt and salt with plenty of fresh water. Use reagent grade methanol or isopropyl alcohol to flush/rinse out the water and blow dry with canned air. Water damage should clean up far easier than heat and smoke damage I would expect!!! Once the units are cleaned up you can decide whether sending them back to the manufacturer(s) for inspection/repair is worthwhile...

Don't give up hope just yet!!!

simply forget about gear.