Stillpoint ERS Paper Question

i have three 8 x 10 inch sheets. 2 on the transformers of tube mono amps and one on top of the ps audio power plant. also, i have a smaller piece on top of the power supply of a tube preamp.

i would assess the effect as one of softening. there is less high frequency energy.

Mrtennis, I would certainly agree. I no longer use any ERS anywhere.

is it less energy or a lessening of extraneous noise?, I have found that I can listen much longer, without fatique, and not want to stop listening.

I don't have any fatique without the ERS. With it the music is lifeless. As always, YMMV.

I have almost a fully covered system and there are no weaknesses whatsoever, just a blacker background and more resolution.

I put everything in separate compartments inside the chassis so as little as possible is touching anything. I put scotch tape at the bottom edges to avoid short circuits and keep the paper elevated a few mm above the circuit boards. The paper is separated 1-2 cm from all cables.

I used 33 sheets of ERS and 1 roll of scotch tape to do it. The only thing I haven't covered is my speaker cable, I used up all the paper in a few days.