hossfly10
Responses from hossfly10
| Honesty is How This Tube Dealer Built His eBay Business 2nd for Brent Jesse.I have dealt with him more than once, and he has been quick to return calls, and more than helpful with advice and descriptions for particular tubes.I would also like to give a shout out to Tyler of tctubes.com Have dealt with... | |
| Cartridge for Sony PS-X6 If you don't want bright, stay away from the Ortofon 2M red.I had one on my Sony PS-X5 for a couple years, and bit the bullet to buy a Denon DL-110.It is more than you want to spend, but it sounds amazingly good, and is a really good match for my ... | |
| Spin Clean fluid I have had really good results using the SpinClean as they direct and vacuuming the fluid off with a Record DoctorV.Noticeable improvement over either method alone. | |
| Subwoofer cable question for those in the know... To answer a few different posts and provide some info...I have a JBL 8400P sub and it has both L/R line level inputs, 50-150hZ variable crossover control, phase switch etc.AES3-MKII preamp (made by Cary) which has 2 sets of L/R line level outputs.... | |
| Not sure where to post my question so I put it here RE: RCA Input switcher... Thanks for the replies all.I ordered the Beresford TC7220 today. It is exactly what I was looking for, but nothing comparable to it ever came up in a search I did. Thanks again for advice. | |
| Not sure where to post my question so I put it here RE: RCA Input switcher... "Be sure to add a pair of 100-150ohm 10W resistor on tube amp side speakers connectors to keep the tube amp permanently loaded and not degrade performance much." imhififan...Correct me if I am thinking wrong here, but as long as my tube amps are... | |
| Not sure where to post my question so I put it here RE: RCA Input switcher... Tube phonostage into tube pre into tube monoblocks into L/R speakers.Using same speakers as Frt. L/R in a 5.1 A/V setup.Wanting to be able to route through a switch so I don't have to reach behind the rack & TV (close quarters) to switch speak... |