kearkg312
Responses from kearkg312
| how to Implement a High Pass Filter in my setup I’m kind of leaning towards the HSU filter myself, that way if I ever change out the subs to ones that don’t have a HPF, it will be an easy swap out. | |
| how to Implement a High Pass Filter in my setup Thanks I think I kept getting confused between sending a stereo signal to the sub and sending a mono . So essentially there’s two options use HPF on sub or use HSU’s oneWhich way would be better? Yes, after I get this setup I would look at buying ... | |
| how to Implement a High Pass Filter in my setup thanks, i had a read through and think i have a good understanding on how to do it. the part where im confused a bit is on the second sub....not sure on how this gets connected in the chain. | |
| how to Implement a High Pass Filter in my setup could you tell me how the connections would work doing this with having two subs though? | |
| how to Implement a High Pass Filter in my setup if i use the sub's high pass filter, does that mean i need to run from the pre amp to the sub then from sub to the amp ? | |
| how to Implement a High Pass Filter in my setup im using a pair of svs pb13 ultra's | |
| how to Implement a High Pass Filter in my setup i was reading the manual for the wyred 4 sound unit and it states this: A loop in/out feature is also on hand with the STI-v2 integrated amplifiers. In the setup menu, you can select the loopfeature to insert a digital crossover or similar device... | |
| how to Implement a High Pass Filter in my setup if I only have one pre out and the run one pair of y adaptors that will give me two connections . So one will go to hpf and one to sub . But then how do I connect the other sub ? So I thought daisy chaining would be the only way | |
| how to Implement a High Pass Filter in my setup Would the hsu Hpf work fine for me? It says I only have to select the two cross over frequencies I want it configured with does not ask me to select impedance . Also I tried to read the manual for the sub but couldn’t find clear instructions on da... | |
| how to Implement a High Pass Filter in my setup i have two svs pb13 ultra subwoofers, so if i split the signal at the pre amp , let's say i have only 1 port. can i use those a pair of those Yadaptors, run one into the HPF which then goes into the power amp. then the other port on the yadaptor, ... | |
| how to Implement a High Pass Filter in my setup hi all after some further research on audiogon forum i have come across a solution that i like, i've re-pasted it here rather than typing it outmyself. from mkgus: the best way I have found to do this is to grab the signal off your main speaker ... | |
| Preamp connection to multiple powered subwoofers In the scenario described by mkgus, im in a similar situation and i have a couple of questions is there a way to do that and also limit full range signal going to the front mains ? So anything below 80hz is going to the sub.are there some examples... | |
| how to Implement a High Pass Filter in my setup i read about using a hsu high pass filter but i saw that needs two pre outs on your pre amp or you have to use a y adaptor. in my case i have two subs so im not sure if i need a preamp with 2 or 3 outputs or if i daisy chain one sub off the other ... |