In 2018 thread where wyn posted and before the first wyn post you posted not one but twice:
""" When you load at a very low value (like less than 100 ohms) its possible to reduce the cartridge output and also decrease high frequency tracking abilities. ( Btw, wyn runs his mandake at 60 ohms and performs fabolous. Obviously no tracking issues. )
"" the cartridge is asked to perform more work as it has to drive the lower resistance. This makes the cartridge cantilever stiffer and less able to track higher frequencies. This is why the resistor can act as a tone control. ""
Curious that in that thread that after the first wyn post there you left alone almarg ( who was supporting you. ) and you did not post nothing again about that cartridge tracking issues not even when wyn posted was FALSE because he measured.
In the other side and in the Etna/Kuzma resonance frequency it needs 3 compliance unit to change its frequency resonance and instead of 12cu we need 10cu. Again how much current is need it to happens that?
R.
""" When you load at a very low value (like less than 100 ohms) its possible to reduce the cartridge output and also decrease high frequency tracking abilities. ( Btw, wyn runs his mandake at 60 ohms and performs fabolous. Obviously no tracking issues. )
"" the cartridge is asked to perform more work as it has to drive the lower resistance. This makes the cartridge cantilever stiffer and less able to track higher frequencies. This is why the resistor can act as a tone control. ""
Curious that in that thread that after the first wyn post there you left alone almarg ( who was supporting you. ) and you did not post nothing again about that cartridge tracking issues not even when wyn posted was FALSE because he measured.
In the other side and in the Etna/Kuzma resonance frequency it needs 3 compliance unit to change its frequency resonance and instead of 12cu we need 10cu. Again how much current is need it to happens that?
R.