Acoustic Zen Matrix..for me???


I am considering a 15 ft. run (RCA to RCA) between my ARC LS25 and my crossover (soon to be directly connected to my ARC VT 100ll amp) on my RS 1-B's. Am I making a good choice?

And if so...what about speaker cables for my speakers and electronics(my base sub woofer system is servo controlled and the speaker cables go back to the xover and then to the subs). I am using Alpha Gore speaker cables now....

The IC's I plan to replace are MIT 330's (15 yrs old).

Thanks gang for all your help and suggestions!
rwd
I just purchased a 15 ft run of Acoustic Zen Silver reference between my SFL2 pre amp and VAC renaissance 70 MK III feeding the Verity audio parsifal encores. They are simply amazing. I understand that the matrix is superb but not as transparent or resolving as the silver. I also owned the 330's. The matrix will make the MIT's sound sick. For less money, I recommend the JPS FX ($750 retail for 15 ft).
You might want to go with a balanced cable. I've tried both rca and xlr with my arc amp and found the xlr was noticably better. ARC recommends this as well. I use a vt100m2 and a bat vk-5i. I've also used/owned the arc ref1 and the ls5mkII with this amp.

I tried the az silver ref ic and thought it was one of the better ic's I've heard. Great harmonic content, no silver harshness, very good transparency and easy to listen to. I did however feel that it was overpriced for it's level of performance.

I didn't hear them a/b, but I did compare both to the same reference cables, and I felt the az and the ht pro silway II were about the same distance off. I would personally just buy an ht pro silway II. If you can find one cheap, you might also try some ARC linklitz cable. Those lose out a little on the transparency, but they are very warm and have a great midrange with arc electronics.

The satori speaker cables are excellent and imho the audio buy of the century. Unless you want to pay for a 3000+ retail speaker cable, I would go no further. I found them to be very close to the best speaker cables out there.

So, buy some ht prosilway II, and some satori's !
Hi John .... I was considering Balanced but my other ic are RCA to RCA and I was told that may not be too good.....

comments?
The idea behind that advice is that running balanced end to end will lower the noise floor overall. This is probably true with all components that are designed as balanced circuits from end to end.

Most of the time I really don't hear that much of an improvment of balanced verses single ended. I usually try both when I have a choice. Balanced verses single ended really is component dependent. Sometimes I hear an improvement, but most times the difference is too small to be concerned with.

I've used a variety of preamps and cables with the vt100m2, and I do hear a marked improvmement running a balanced cable from pre to amp. A long ic is also better served with a balanced cable because of it's noise cancelling characteristics.
I think the Silver Ref is better than the Matrix, but it should be at half the price, more open better detail etc.. I think the Silver Ref is at a much higher level than Pro Silway 2, Matrix is even much better than Pro Silway 2 in my system. I have owned them all at the same time and compared them directly. Just because Zen's designer used to work for HT and the cables both utilize zero crystal design doesn't mean they sound the same. In my opinion the Zen cables are the best I have tried at any price including very expensive stuff.