Amp repair...What to expect.

My sunfire SRA is predecessor to 300 and needs an attention because it became noisy at idle. So far I've done reapplying a fresh solder to input XLR jacks and to binding posts and all of power transformer outputs. It solved problem partially, but my next step is ongoing to test power-supply caps and replace them. Another culprit of decreased performance quality is actual wear of Tripath chip(very inexpensive itself and very easy to replace) that will need replacement together with provided service(I'm not sure if that was done, but very very likely).
My expectation that I will
1. get rid of humm
2. get some edginess or brightness while tripath chip(that is a logical circuit) will 'adopt' to the output stage for the next 20...50 hours of listening.
3. i don't plan to expect loss of sound detail though and don't know the particular reason for that.

I love the sound of my sunfire 300 and I'm using both current and voltage outputs to the different drivers.
The right channel blew out, so I sent it for repair and told them to also upgrade the electronics. Now, the amp sounds nothing like it did before service. Loss of detail, 3D image was huge and is gone.
Theduke answered my question somewhat, but how many hours is the typical burnin period?

should not take long. maybe a week full of listening or running some music at low volume levels.

Minimum of 200-300 hours. Maybe as long as 400-500 hours.

Thanks, Mofi. It's frustrating because it's not like burning in a new tube or a cable, which can be an adventure. In this case we know the sound of our system and now it's a waiting game to get back to that sound we know so well.