2. amps-preamps
  3. 1277589577

BAT VK-52SE - Unity Gain/HT Bypass help

I could use some advice in getting this to function correctly. I have connected balanced interconnects from the processor out to the Aux 2 input on the preamp. I have selected Aux 2 in the programming function and set the unity setting to "fixed" and left the volume at 000 (also tried 001). When I run from the processor (with preamp on, not muted, and Aux 2 selected) I get nothing out of the mains (which work correctly in two channel). Anyone have advice?
chessman
5 responses Add your response
chessman OP
26 posts
 
It does not work when set to not fixed. The processor output is connected via XLR. A different preamp (different brand) with a HT bypass works perfectly when connected to the processor. I guess that tells me what I need to know.
sidssp
1,077 posts
 
This is strange. Does it work if you don't set Aux 2 to fixed?

Also which processor are you using? Is its output RCA or XLR?
chessman OP
26 posts
 
I tried 100 - no joy.
vjay00
37 posts
 
The volume setting on the BAT 52SE still has to be matched to the processor and other sources, so the processor volume control can operate normally, as if the BAT wasn't in the loop. I have my 51SE set at 110 (step mode).
sidssp
1,077 posts
 
Volume readout can be configured to show either db or step. From what you
described, it seems to me it is configured to show steps because you can change
it to 001 (in db mode, the minimum is +- 0.5db). So 000 means the minimum
and therefore no sound. If you change it to db mode and set it to 0 than it means
0db or unity gain.

BTW, in step mode I think 100 is unity gain but I can't be 100% sure because I
don't have the manual with me.
Log in to respond
More to discover
80x80
Rotel RC-1590
80x80
Ayon Audio AYON CROSSFIRE P/A STEREO AMP
80x80
Ayon Audio Ayon Triton EVO Mono Amps Pure Class A