My bad - I had the EQ bypassed while trying to EQ! You are right about playing the pink noise at a high level to improve the S/N ratio. There was some low frequency noise visible at about -65 dB. I could hear it pulsing, and thought something was sending my subwoofers into oscillations, or the EQ was noisy. Turns out they are re-paving the Mass Pike not too far from my house. Just my luck!
Behringer DEQ2496 HELP
After reading the raves about this product, I finally bought one along with the matching microphone tonite. Put in my system, eager to try room correction. The first 2 attmepts produced some curves that I wasn't crazy about, but seemed plausioble. Now, all it does is push all the bands above 125 all the way to maximum boost, and all the bands below 125 to maximum cut. When displaying the RTA of the pink noise, there is nop more htan a 15 dB range between the highest and lowest levels on the curve (as if that were small!)Also, one of the primary reasons I bought it was for equalizing low frequency room problems, yet it suggests htat anyuthing below 100Hz not be included in the auto EQ.
Does anyone know why it is coming up with such odd equalization curves, even though it is reading the data, which doesn't look so bad? Also, how bad is the product at low frequencies?
Does anyone know why it is coming up with such odd equalization curves, even though it is reading the data, which doesn't look so bad? Also, how bad is the product at low frequencies?
- ...
- 136 posts total
- 136 posts total