Behringer DEQ2496 - worth using in hi-end system?

I have two of them, for front left and right and surround. They do a better job than the parametric I have on the center front.

I am suggesting to people that they buy one thinking only of using it only as a spectrum analyser. (That way you don't need to come to terms with the audiophile sin of puting a digital device in your signal path). After you hook it up, and see how bad your room response is, you will inevitably activate the auto equalization process, (just as an experiment of course). This is, in a word, "neat". Now listen to some music. You will never look back.

Thanks for the tip Eldartford.Going to go shopping,Bob

Thanks, I will try it. When you think about it it costs as much as a decent interconnect but the potential gains may be worth thousands. I am just afraid about their reliability, there seems to a lot of quality problems as of recently.

I bought one recently for the following system:GNSC modified Wadia 850 / Atma-Sphere MA1s or Pass Aleph3 / Talon audio Hawks + a set of 4 Entec LF20 subwoofers. The system is very highly resolving. The Behringer when used full range and set flat was very transparent, but not completely invisible. There was a very slight loss in dynamics and a very slight loss in resolution. But these losses were very small, especially compared to the losses that might be introduced by a pre-amp. I have tried only 2 pres in my current system - my beloved old standby Classe CP-35 and an Audio Research SP-25 MkII. Both were far more colored than the Behringer, the classe reducing dynamics and the AR causing a loss in resolution of vibrance. I say this not to badmouth either pre-amp, but to show how good the Behringer is. I am currently using the Behringer only on the subwoofers, because when applied to the entire signal, the main speakers get overdriven by mid bass (which needs boosting in my setup). I have been enjoying the music much more now than I have in a long time. I would recommend this product to all but the very best system / room combinations.

Thanks Honest1, thats a very valuable input. My system is also very resolving and I would only be trying to boost some upper bass regions. Do you use the analog in/outs or just digital path?