Benz Micro Ruby 2 Impedance Adjustment

Well,,the rule of thumb is 10-20 times the internal impedance. Not sure about the Ruby II, but for my Benz LP the internal impedance is 38, so the range would ideally be 380 to 760. I starded out with 47 k on my Pass Xonon, and that was way too bright. Currently trying 1000, which is a lot better but perhpas still too high. The cartdige and tonearm cable are still breing in, so I will wait a bit before I try to go lower...There was a recent review in a UK magazine by Scott Markwell (sp) who alos writes for TAS. He personally liked the LP at 47 k, and I know that AJ Conti prefer this setting with the LP as well (private email). In the end its up to you - in general , a higher setting will emphasize the top end if you go to low the bass will get slushy. You may want to post the question on Audioasylum and/or search their archives...

I ran the Ruby with 47 K.

Excellent results, but it is probably depending on System.

I tried ranges all over the map. Ruby2 will sound slow with loading. Load between 15k-47k is my input.

If you are able to easily enough adjust the loading on your phonostage, I would be all means do some experimentation of your own over the entire range provided. There are several threads in the Audiogon archive dealing with this question if you search.

load