Best mm cart for VPI scout/jmv-9 memorial arm

From reading other forums I found that the only drawback to replacing the tip of a Soundsmith is the wait time. The wait time average being somewhere around 2 months. A replacement or upgrade for the 2m Bronze would be anywhere from same day to up to a week* (if ordered via the net*).

If there was a significant edge to using the Otello I would not mind the wait. But if it's a wash then I would go with the @m Bronze.

So is there any difference in the quality of sound each one produces?

So I picked up an Ortofon 2m Bronze.

Any suggestions on phono cables? I'm temporarily using a pair of monster interconnects that was used for a CDP and a piece of 16g solid copper wire for a ground between the receiver and TT.

I have a hum issue when the record is playing and a light static sound when not playing a record coming through my speakers.

I am using the phono amp in the Onkyo for now. The cables will need to be shielded due to their location, which is on either side of a table standing Sony 46" LCD TV about 5-6 feet apart.

I can't relocate anything for now so that is out of the question.

Not looking to spend a lot of money on them. I know some of you think expensive ones yields good things. While others think it's fools gold to spend a ton on interconnects.

Please be specific with the brand names and model # of the cables you would recommend.

Thank you

Look at the web site moon-audio.com and ask Drew Baird for advice.

Please at least consider morrow audio phono cables. Inexpensive and I have found them to be close to the performance of cardas tone arm cable.