My misunderstanding with the Minus K... there are so many different racks out there; I may have been confused. I think someone had mentioned them being active as many of the active platforms that we have tested and even on my data sheet has been errantly marked active. I could have sworn the Minus K plugged in, leveled and even displayed when vibration was present. I think I like the Minus K much more since they are not an active servo system... what a nice intro they have with the wine glasses from a passive device! It is very hard to control very low resonant frequencies and will be the FIRST to say that ANY rack cannot dampen 100% of the spectrum especially at higher than miniscule velocities.
Best rack for non-suspension turntable?
I have a Well-Tempered Classic turntable. For those unfamiliar, it does not have any internal suspension.
Does anyone have an opinion about the best type of equipment rack for this kind of table? My options are the Naim Fraim (I have Naim electronics, but the Fraim is obscenely expensive) which is rigid with glass shelves or the Isoblue which is composed of layers of different woods (so I'm told).
The Fraim supposedly is unbeatable with a suspension table like an LP12, but I'm not sure how it would work with a non-suspended table.
Any opinions?
Does anyone have an opinion about the best type of equipment rack for this kind of table? My options are the Naim Fraim (I have Naim electronics, but the Fraim is obscenely expensive) which is rigid with glass shelves or the Isoblue which is composed of layers of different woods (so I'm told).
The Fraim supposedly is unbeatable with a suspension table like an LP12, but I'm not sure how it would work with a non-suspended table.
Any opinions?
- ...
- 40 posts total
- 40 posts total