Best rack for non-suspension turntable?


I have a Well-Tempered Classic turntable. For those unfamiliar, it does not have any internal suspension.

Does anyone have an opinion about the best type of equipment rack for this kind of table? My options are the Naim Fraim (I have Naim electronics, but the Fraim is obscenely expensive) which is rigid with glass shelves or the Isoblue which is composed of layers of different woods (so I'm told).

The Fraim supposedly is unbeatable with a suspension table like an LP12, but I'm not sure how it would work with a non-suspended table.

Any opinions?
turboglo
Audiavreseller, I don't think the Minus K is a active isolator as it doesn't use electricity. I think it too is just springs done in an innovative manner. The Audiav clearly is just a rack. The only active isolator is the Halcyonics which I will attest to as exceptional.
Every material has a set of resonant frequencies (mode spectrum). I believe you may be referring to the boundary conditions that apply to the problem and this is why I qualified my comment with the phrase "All other things being equal, . . . ." The example of a partially buried telephone pole shows how boundary conditions affect resonance - one end of the pole is clamped, which shortens the effective length of the pole and raises the resonant frequency.

Layers of adhesive or semi-adhesive polymers like Sorbothane also have resonant behavior; the natural frequency depends on the size and shape of the layer. The product web site has data and a nice downloadable calculator to compute resonant frequencies for various applications. On looking into this, I was interested to learn that it's pretty difficult to get the material's resonant frequency much below 5 Hz in any real-world application, especially for thin layers covering large areas.

I'd also like to point out that the Minus-k products contain no servos; they are completely passive. The principle behind these products is to use a coupled spring-flexure system in which some of the springs are near their buckling points. This can create a negative-stiffness situation, hence "minus-k."
My misunderstanding with the Minus K... there are so many different racks out there; I may have been confused. I think someone had mentioned them being active as many of the active platforms that we have tested and even on my data sheet has been errantly marked active. I could have sworn the Minus K plugged in, leveled and even displayed when vibration was present. I think I like the Minus K much more since they are not an active servo system... what a nice intro they have with the wine glasses from a passive device! It is very hard to control very low resonant frequencies and will be the FIRST to say that ANY rack cannot dampen 100% of the spectrum especially at higher than miniscule velocities.
Audiavreseller, it is the Halcyonics that is active and far superior to the Minus K. I own two and wish I could afford more.
.
Tbg,
.
Have you heard a Minus K in your system and done a direct comparison between the Minus K and the Halcyonics ?
.
If not in your system, have you heard both devices compared in the same system at the same time under the same piece of equipment ?
.
Rgds,
Larry
.