Built a Flexi-type rack?


I'm wondering about building a thread rod and butcher block type rack. Anthing other than the appropriate size nuts for for spacing the shelves? (Washers? Bushings?) Attractive treatment for top of rods? Effective treatment for footers? (Rack would sit on hardwood floor.)

Thanks!!

John
jdoris
I used Pennsylvania slate instead of the butcher block. Rubber bushings in between the washers and stone to provide some damping. I'm currently in the process of building a new one with granite. Good luck.
My "flexi" was built using 2" maple, sized at 24" x 24". My upright support rods are 3/4"-10 threaded brass from McMaster-Carr, with all brass fittings - nuts, washers and top acorn nuts. For the spikes, I used Audio Points (model 2.0AP-1OINT). I have four shelves and a total height of 48 inches. The rack weighs in at around 300 lbs, and sits on a fiberglass reinforced concrete basement floor. Holes were cut in the maple using a 13/16" forstner bit. Rear legs offset toward center by 1" (each side) from the front legs, mainly to break up vibrations as a result of symmetry (think of a perfectly square listening room and the resulting sound - I believe the same problems occur on a much smaller scale vibrationally in a rack). I had prototyped several flexi models using steel rod and hardware, and several types of shelf material (furniture grade plywood, MDF, several composite laminates, etc) but found the thick maple to perform the best. I also believe brass to be one of the better metals to use in audio applications (there are numerous discussions online as to the relative merits of various metal types for audio use). Personally, I found that rubber-type damping materials either as through-hole bushings or as spacers between the washers dampened the sound to a degree I personally didn't care for, and seemed to detract from the overall dynamics of the system. Since I utilize brass Audio Points under all my components on the rack, the coupling/mechnical diode effects of the points seem to form a synergistic relationship with the rack itself, and measurable vibration seems nearly nonexistent. Of course, YMMV depending on existing substructure (wooden floors, etc), other types of isolation products already deployed, and personal taste. Happy building.

-Richard
Richard,
I did an estimate based on your description and parts list, and it comes exactly the price of a similar rack from Mapleshade Records.
The only difference is that Mapleshade uses steel rods, not brass.
Could you please share how much $$$ it cost you to built yours?
Regards
As I recall, the final cost of materials was right around $550 - a simple breakdown was $275 for the maple (sourced from a local millworking company), another $125 for the brass audiopoints, and around $150 or so for the brass bits from McMaster-Carr. A similar rack from Mapleshade is right around $1000 + shipping. The basic differences are in upright diameter (1.25" steel on the Mapleshade vs. my .75" brass ), and in the shelf dimensions, where I use a 24" x 24" shelf, the Mapleshade uses a more "standard" rectangular audio size of 24" x 15". I also dispensed with the Amish craftsmen ;-))

-Richard
Thanks Richard,
I got a price from McMaster website:
Brass rods 3'-$47x4= $188
6'-$77x4= $308
They don't have 4' length listed

Brass nuts and washers- appr. $150
Plus maple.
You obviously didn't pay much for 4 shelves in that size.
A guy of Timbernation that sells maple blocks on A-gon would charge $720 for 4 18x24x2 shelves.
Are you in Pennsylvania or NJ? If you could share a source of the maple, it would be greatly appreciated.
Ilia