Cable Goop Review George is going to freak!!

Thanks for your input ozzy. Did you put any 1260 on your PSA fuses and if so was it about a week like the SR fuse? Did you coat all or most of fuse end? Also on the power cords were they the same too? It is hard for me to admit but i tried and now find it hard to live without the QSA red and black fuse in my Sorcer. I justified it by spreading it between my birthday and christmas gift to myself. For a complete picture I need to tell that i ordered a plastic top for Sorcer. So as i was testing back and forth changing fuses i noticed a big difference by leaving top off than on even with the plastic top. The harmonics seem to dramatically increase and improve with top off. 
    My girlfriend plays an electric keyboard in the next room to my stereo and it greatly improved with top off and QSA fuse installed.She and i heard it almost immediately. The harmonics  I will mention the only fuse in my stereo is in the Sorcer, so not sure if that is a factor as to outsized difference the QSA fuse had. Just count me a happy and satisfied music lover!

sgordon1,
I removed the TC long before using the 1260.

marc777,
I coated the complete ends of the fuses including the end sides. Didn’t take much of the solution to do it. The power cords were coating about a 1/3 of the way down on all sides including ground.

So, you are saying to remove the top of the Sorcer? Interesting, you may have something there, I will try it once I get another QSA fuse.

ozzy

Hey ozzy the NPS-1260 will be here soon and i was wondering did you use it on the RCA jacks of equipment the cables plug into? Also did use it with usb or anywhere else you would advise? Any warnings you can point out? I thank you for all your input.
   Yes for me there is a big difference with top off of sorcer which is right next to my integrated amp. I am curious if anyone else has same reaction. 

marc777,
I did use the 1260 on a digital rca, just a little on the tip and I also applied it to a F connector for my Satellite connection. Didn't try it on any usb. The 1260 is conductive so it would be too hard to apply in such a close connection point. IMHO that is.
Someday somewhere down the line I do intend in applying it to my  breakers at the box that power my audio.
ozzy

Will treat the interior of my preamp next..then the ac connections and all my outlets on my sound wall and the 3 dedicated breakers and inlet line to the  ac subbox. 
Doing a speaker rebuild will definitely treat all the new lines and connections to and from. The woofer tensile lead maybe a game changer and the solder joints to the voice coil..I may even do the voice coil even though it has enameled wire. Works on soldered connections why not over the enamel even if 25% effective it would be worth the hassle. Tom