Connecting dual subs with speakon connectors

@ghdprentice  the high level input is the reconended input for this subwoofer.

@ditusa thank you very much. Sadly the manual has no mention of how to connect two subwoofers...

@noromance ​​​+ @artemus_5 : Thank you very much, I think this is what I was looking for. This makes a lot if sense as the yellow and red wires go to the two positive (red) speaker outputs when connecting one subwoofer. Just to clarify, I would connect one subwoofer with red and yellow to the positive speaker out of the left channel and black to the negative speaker out of the left channel and the other subwoofer with red and yellow to the positive speaker out of th right channel and black to the negative speaker out of the right channel?

Thank you very much for your help!

Yes

R*L = +    f L channel

B  =   ---       

Hook one to L, The other to R. Good to go. You may have to float your black IF you get a hum.              

• No problem. Just twist the same colors (from both subs) together and connect as the manual describes (for a single sub). I am running 2 subs this way. Works perfectly.

@the-audiophile-barista perfect thank you very much this is what I hoped someone would write :)

“Just twist the same colors (from both subs) together and connect as the manual describes (for a single sub).”

NO!!!🤦‍♂️

The correct way to connect two subs with high level input would be what @noromance said, if you find the gain is too high then float the yellow wire.

“Red and yellow (together) to + / black to – on each channel on the power amp.”