I wasn't able to include a picture of the full specs, so here they are.
Power Output Stereo
Minimum sine wave continuous average power output per
channel, with both channels operating is:
200 watts into 8 ohm load
320 watts into 4 ohm load
Output Load Impedance
8 or 4 ohms
Rated Power Band
20Hz to 20,000Hz
Total Harmonic Distortion
0.03% maximum with both channels operating from 250
milliwatts to rated power, 20Hz to 20,000Hz
Intermodulation Distortion
0.03% maximum, if the instantaneous peak power output
does not exceed twice the rated power output for any com-
bination of frequencies from 20Hz to 20,000Hz
Dynamic Headroom
1.5dB
Wide Band Damping Factor
Greater than 200 - 8 ohm, Greater than 100 - 4 ohm
Power Guard
Less than 2% THD with up to 16dB overdrive at 1,000Hz
Frequency Response
+0, -0.5dB from 20Hz to 20,000Hz
+0, -3dB from 10Hz to 100,000Hz
Preamplifier Output Impedance
500 ohms
Sensitivity (for rated output)
High Level - 250mV unbalanced, 500mV balanced
Phono - 2.5mV
Signal To Noise Ratio (A-Weighted)
High Level - 93dB below rated output
Phono - 82dB below 5mV input
Input Impedance
High Level - 20K ohms
Phono - 47K ohms; 50pF-800pF
Preamplifier Output 2 (for rated input)
1.4V unbalanced (8V Maximun)
Maximum Input Signal
High Level - 8V unbalanced, 16V balanced
Phono - 80mV
Voltage Gain
High Level to Output 1: 44dB
High Level to Output 2: 15dB
Phono to Output 1: 84dB
Phono to Output 2: 55dB
Headphone Impedance
100 to 600 ohms