Fuse Blowing on Superamp AE 25

I will still be waiting for fuses for a while, but I have checked all tubes with an ohm meter, and checked to fuses on the current source tubes. Nothing unusual. of course, it may be that the low voltage of the ohm meter may show nothing that occurs at high voltage. Still, at only a few hundred volts, there wouldn't be any significant dielectric breakdown, I would think. Am I wrong?

Tubes can short or open internally, as they heat up. There's a big difference between the(typical) 9 volts of a multimeter and the 400 to 600 volt B+, of an average tubed circuit.

Thanks for all the input. I have spent some more time reading and measuring. First, the Superamp does not have any bias adjustment - it is auto-biased - so I don't have to worry about that. Second, I checked the resistors in each bias circuit, and all are reading within a few percent of their stated values. Finally, and I don't know how this fits in, the Superamp has a 1/2 amp fuse at the bottom of the bias circuits (between the resistors and ground) and that fuse is intact. Nevertheless, I have just ordered a new set of power tubes, EL-34's, which the Superamp will take with no adjustments required (using KT-88's now) and when the bits arrive (fuses, and tubes), I'll try them out. Hopefully my problem will be solved.

If your 1/2A fuses are good; it's probably not an output tube problem. Hopefully, just a weakened fuse and not something power supply related.

Yes! The power supply is essentially a single transformer with a centre tap and two output windings. If that has gone it will be a bugger to replace. There are two chokes, so I will check their resistance now.