Harbeth SHL 5 amplification

In reviewing the Harbeth website there seems to be a strong bias towards high power solid state amplification. When I heard the SHL 5 on demo it was with the smallest Rogers Fidelity amplifier and for the most part it worked.  I run a Leben CS600  -with a modest 32 watts per channel and wonder if this will suffice to run a pair of SHL5's.  After reading the Harbeth user group's opinions, it seems it might be risky; though there does seem to be a tremendous under appreciation for the virtues on tube amplification on the Harbeth website.
Any thoughts?
It depends on your room size.  
Since I prefer tubes and have a medium / medium large room I use a higher powered tube integrated that uses KT120 tubes for a solid 100 WPC on my Harbeths and love the sound- plenty robust and dynamic.  
I am currently talking to a customer about this exact speaker with a desire to driver it with my Diavolo which is a 10W SET. Incidentally I am advising against that.

The issue is headroom for dynamics. The question is at what level do you usually listen and how much headroom do you need. My rule of thumb is that most people list at about 80dB for reference listening and you want 10-15dB of headroom for music. For home theater reference is 85dB and 20dB of headroom is essential. 10w will deliver 92.3dB of volume and most of the time, headroom will be adequate but every now and then musical dynamics are going to push the amp too far. 

For those speakers in a small to medium room, 18w will give you 94.9dB of volume 10’ from the listening location. For most music this is plenty assuming you are not turning up to 11. I chose 18w because that is the power output of my Carissa SET. 32w will deliver 97dB.  Fine for music.  

Alternatively, for home theater where you really need to be able to hit 105dB, you need 185w of power. That means a high power SS most likely or a high powered tube though I tend to prefer high power SS amps to high power tube amps. Musical Fidelity is an amazing match for Harbeth.

It comes down to how you are going to use it.  

Thats very helpful. My listening area is about 20 x 14.  We listen at mainly medium volume to music/ no home theater. I am currently driving a pair of Spendor SP-1 speakers which I believe have similar efficiency to the Harbeth speakers.  The amp seems to do fine with them; I am looking to modernize a bit.
Thanks for the insight
I heard Harbeth P7se (2? 3?) at a T.H.E. show in 'Vegas around 2007. They were driven by Plinius SA 103 and were stunning.
The SHL5+ requires some power to wake up. If going tubes I would recommend a stronger amp with 35+ watts. I’ve tried 30 and under and it simply wasn’t enough. The MastersounD BoX and Triode TRV-88ser did well powering them. I don’t recommend Single ended amps with these unless it’s a beefy parallel Single ended one. 

On on the other hand, the 30.2 absolutely sings with a modestly powered tube amp.