2. analog
  3. 1419686372

Help me improve Rega P2

Wondering about the most (cost) effective tweaks to improve my P2. Currently have a Goldring Elektra cartridge and feeds into a Creek OBH-8 phono stage and then into solid state preamp and amp. Speakers are Symphonic Line Legato. I would think that a new cartridge might provide biggest change but wonder what others would think. Considering the Rega Bias 2 or Elys 2 mostly for ease of installation and alignment as well as presumed synergy. Certainly I'm open to other suggestions. Other considerations would be a new sub-platter(the one from Argentina) or new mat. Should mention that I have the glass platter, white belt and thick felt mat. Don't really have a specific complaint about the current system except that I suspect it can sound better. Perhaps more full sound or better bass. Willing to spend up to $300 so not interested in suggestions to get a better TT.
Thanks in advance. Jim
jmg1949
almarg's avatar
Ag insider logo xs@2x
almarg
9,670 posts
 
Phasecorrect, the OP's present cartridge has a recommended load capacitance range of 150 to 400 pf. The 2M Blue that was suggested has a recommended load capacitance range of 150 to only 300 pf. My rough estimate of approximately how much load capacitance his equipment presents to whatever cartridge he uses was 400 to 450 pf.
... so I don't feel the cap mismatch is a major issue in this circumstance...maybe in a higher end system...
You may be right, or you may not be. I don't think any of us is in a position to say for sure. My point is why take a chance? There are lots of MM's and HOMC's out there for which the manufacturer recommends higher load capacitances than what is recommended for the 2M, as a perusal of the cartridge listings at NeedleDoctor.com and other sellers will show. The suggestion by Mesch to call them was a good one.

Regards,
-- Al
kiko65
279 posts
 
Mattmiller,
2M Blue and Reference sub-plater will cost you $500.00 plus when you factor in s/h expenses. I still think that the 2M Red/Bellari is a much better option around $350.00 which comes closer to Jmg's budget.
phasecorrect's avatar
phasecorrect
2,013 posts
 
Sound advice!...no pun intended...I was thinking more of his current set up...but if swap catridges who knows...back to my no brainer solution..upgrade the stylus... That will improve sonics with little monkey business
stringreen's avatar
stringreen
6,468 posts
 
Why go through these expensive contortions.....you may be satisfied with the increased definition, cleaner lows, and midrange improvements by just putting the table on Cardas blocks.
Post removed 
More to discover