Help Need to combine L and R feeds for mono amp

Hey Ar_t - thank you. Will try.
Cccc

Try this:

1 kilohm to each output. Tie the loose ends together. Take that into your mono amp. You may have to juggle the value some, and perhaps add a resistor to ground at that common point.

Thanks Ericjcabrera - I will look into that as soon as I get to town.

Thanks also Rlwainwright. I had tried using a reversed splitter and got poor mono signal, and then was advised by a nice person on thTs forum that doing so would cause more than one problem. Yhat individual suggested a simple "bridge" but did not give specifics. Thus, my request.

Anyone else have some info?

Cccc

Can't you simply use a splitter?

http://www.monoprice.com/products/product.asp?c_id=104&cp_id=10401&cs_id=1040107&p_id=326&seq=1&format=2

-RW-