high power tube amps vs ss


I have always had low efficiancy speakers and had powerfull ss amps to power them. Now I see there are a number of tube amps in the 150 - 200 WPC range. My questions is: is there anything to be gained by switching to these higher power tube amps over ss amps?
winggo
Audiogon often seems a magnet for unique or differing perspectives on good sound. SS is old hat and boring. Does not attract much attention these days as a technology. Class D amps are newer and get a lot of attention here. Tubes are cooler and more unique these days, as is vinyl.

I'm working on building more appreciation for Walsh style speakers here on A'gon myself in that I believe Lincoln Walsh used his engineering experience with radar systems in WW2 to get dynamic speakers right while the rest of the world missed the boat. Pretty radical....

The odd ordered harmonics are perceived as sound pressure level comment is interesting to me. I recently switched from all tube amplification to a very good tube preamp and very low distortion and high current solid state amps. Musical transients are now much more impactful and realistic spls are acheived and not perceived as loud, (lack of odd order harmonic distortion?)Very happy with the results with one caveat. Using my sound meter I am now regularly listening to music in the mid 90 to low 100 db range and starting to get some evidence that I'm affecting my hearing. Maybe I was better off with the even ordered tube harmonic distortion satiety at about 10 to 15 db less sound pressure level and not going deaf. Go figure.
05-24-13: Mapman
... I believe Lincoln Walsh used his engineering experience with radar systems in WW2 to get dynamic speakers right while the rest of the world missed the boat. Pretty radical.
Interestingly, as far as I am aware he was also the only manufacturer of consumer-oriented audio power amplifiers utilizing the 300B directly heated triode power tube, between the earliest days of hifi and the resurgence of interest in that tube that occurred in the last three decades or so.

Also, some of his amplifiers used 2A3 DHT power tubes, and similar comments apply to them, with the slight qualification that his use of 2A3s was preceded by their use in the power amplifier sections of certain high end radios of the 1930s.

Those Brook Electronics Company amplifiers are highly collectable these days, and go for big $$$ on the rare occasions when they appear for sale.

Best,
-- Al
So, individual technical peeves and preferences aside, in the end here are things I think really matter regarding choice of amp and speakers to match.

1) If limited frequency range down to only 50-60 hz or so is your game, the world is your oyster. Many many good combos of both SS or tube amps and speakers to do that.

2) If full range frequency response flat to down below 40 hz or so is your target, now you have some important choices to make, especially for a larger room in that in the end, however you achieve it large volumes of air must be highly pressurized at low frequencies to achieve the goal. Choices are:

1) modest or low power tube amp + higher efficiency larger speakers. The lower power the amp the larger the speakers will need to be. Soft clipping of transients at high volumes is still clipping so you have to avoid that!

2) Higher power SS or tube amp with smaller speakers. Lower efficiency speakers will also still require more power. Class D amps may be the emerging technical solution that best addresses this. Otherwise those high power amps needed will be large , heavy, expensive to buy, and expensive to run as well.