2. amps-preamps
  3. 148905-976

How far have ss amps really come in the last twenty years?

I have owned and enjoyed my Jeff Rowland model 8 ( recently modded and upgraded by Jeff to the last version) for many years. I recently had the opportunity of comparing it ( after mods) to a few of the current ss models from Gamut, D'Agostino, YBA, Parasound, Sim audio, CH precision, Constellation,PS audio,Pass Labs  and Musical Fidelity. The results were very interesting, because to my ears and in the systems that we did the comparison, the Rowland held its own against all but the most expensive D'Ag and CH amps. Even those were only very slightly outclassing the Rowland in the areas of top end resolution...and a tad in the bottom end resolution. Now the thing is that the last revision to the Rowland 8 was designed by Jeff over ten years ago! 
So, my question for those more technically inclined than myself is...how far has the design of ss amps come in the last ten...or even twenty years? 
128x128daveyf
daveyf's avatar
daveyf OP
2,963 posts
 
@mgattmch   I would bet that your old Krell KSA 250 would give most ss amps today a very tough run for their money! 

@stringreen  What you describe must be a bit infuriating! If it is just in the left channel, have you tried simple things like swapping all the cables..left to right etc. 
A resonance sound could be coming from the furniture in the room as well. That is what I have noticed when I have had issues like that, and they can be difficult to suss out!
stringreen's avatar
stringreen
6,492 posts
 
Frustrating is right Dave..... Tried left/right cable swap and remained in the left...I even tried entirely different brand of cables...no luck. Moved the chairs/sofa to another room....same.
mgattmch
576 posts
 
"mrdecibel" and "daveyf", I stupidly did. The Krell KSA-250 was part of a 5.1 HT set-up that doubled as a stereo system. I used the Krell for front L/R and two Pioneer Elite M91 amps for rear L/R and one for the center channel. Sure looked nice. But, the whole system was heating up my HT room dramatically in the summer (I lived near Houston at the time). So I replaced all three SS amps with a Krell TAS. Heating problem solved. But, it was obvious the Krell TAS was not in the same league as the KSA-250. Like I said, I have regretted the decision to sell the KSA-250 ever since. Probably my single most stupid HiFi decision in close on 50 years with this wonderful hobby! But then again, probably best not to talk about the Wharfedale E90 speakers.

The nice thing about the Krell TAS versus the KSA-250 is reliability. The KSA-250 runs so hot it is obvious a re-capping will be required at sometime or something will fail due to the extreme heat. Not so with the TAS, the Krell service department tell me this is an extremely reliable amp and very rarely needs repair. Ah well, peace of mind is worth something in this instance.
daveyf's avatar
daveyf OP
2,963 posts
 
@stringreen   Wow, strange. I think that there could still be a room node that you are hearing. Do you have any acoustical damping in your room/system?

@mgattmch  That is one of the issues that I think has gotten significantly better with many ss amps over the years....far less heat production. Although, the Class D amps, which run cool, leave a lot to be desired IME. Personally, a heat engine for an amp, isn't going to be on my radar anymore. 
Post removed 
More to discover