Intelligability Problem


Can anyone give me a heads up on what to check... I have a Denon receiver, Panasonic Blu-Ray player, and NHT towers, center channel, surrounds, and sub. TV sound is fine, but Blu Ray, and even reg. DVD is fuzzy, and unintelligible. Any suggestions??
128x128stringreen
Thanks for the replies. I find that music and background sound is very good indeed. I am letting the BluRay player decode and am using the 5 analogue outputs to the Denon which is in ext. mode...meaning it is acting as 5 separate basic amps with a volume control. Speech coming from the center channel sounds totally muffled and sounds as though its from a 39cent speaker, although the NHT supposed to match the other speakers in sound quality. I am using HDMI directly from the Panasonic to the Sony hidef for video only, since my Denon has no provision for HDMI. I have adjusted the Panasonic to recognize that only video is HDMI. Any suggestions?
Do you have your TV muted? I used to run the HDMI direct to my TV and the sound to my pre/pro. If I forgot to mute my TV the timing in the sound from my TV did not match that coming from my HT system and it made it very difficult to understand. While you wrote that only the video is being sent via the HDMI to the TV, I would double check this. Since you indicate that this only happens with videos (vs. music only), it may be the cause.

Outside of this, it would seem it would be a set-up issue. If I am correct, you have run the full set-up, speaker placement/distances, etc. . . from the DVD player and during set-up the test signals all worked well?

I just keep going back in my mind to the dual outputs using the HDMI and the analog 5.1 channel output. Since it is not your HT receiver that is decoding anything (ie. based on the analog input approach and assuming you haven't programmed the Denon to do any changes to the analog signal).

I don't think my DVD player (Oppo) allows me to restrict the HDMI output to just video, but I may be mistaken.
As other have suggested I would check:

1) The set-up parameters of the center channel in the Denon

2) Use a different input/channel of the Denon for the center to see if it a problem within the Denon specific to the center input you are using (e.g. bad amp channel)

3) If possible substitute a satellite speaker for the center speaker to see if the problem is the speaker itself

4) Also play music through all channels as another way to check the center speaker

5) Turn off the center channel in the panasonic so the dialogue is handled by the front L and R speakers

This all should help pinpoint the problem.
Thanks for the suggestions. When I put my ear to the center channel, it is working...its just the QUALITY (bad) of that speaker is not good. I will connect the output wires that go into the center channel to one of the towers to see if it is indeed a defective center channel speaker. I'll get back. Thanks again. By the way...there is a definite page for HDMI distribution on my BD-55 Panasonic... HDMI Video, HDMI Audio, Both. I have it set only to Video. The TV sound is set to "off" on the Sony.