Is a subwoofer 'overkill?'


i just bought a subwoofer hereabouts. The deal want well and i hooked it up. i can certainly 'hear' it. My wife is agast.

Yes, even at the lowest settings it sounds a bit loud.

Thoughts. Should I save it for movies? Turn it off when she gets home?

Note; This is a woman who can hear changes I make when I roll my tubes, better than I can. She know even when I don't tell her.

Bummer: the wife has zero appreciation of high-end audio, but hears better than me.
unclejeff
Sounds like it's not set up properly. Possible that:

1) the crossover point is set too high so that it is doubling up frequencies already output at good volumes from your main speakers
2) the volume is still set too loud
3) the placement is bad

I recently added two subs and found that an SPL meter helped a fair bit to verify what I was hearing. I don't have true flat response but I have been able to get it close enough that my system definitely sounds richer without the bass playing any louder than the rest of the music.

Bottom line - keep experimenting - this takes days, not hours...
Pull the sub further away from the room boundaries to tame the loudness factor, or sell the wife... :^(
Sounds to me like there isn't optimal integration. When crossovers, phase & level are correctly adjusted, there should be no distinct impression of bass heaviness or low frequency accentuation, just a sense of greater acoustic space, a clearer acoustic window into the music that's fleshed out with harmonic completeness. A good start for inexpensive help is Rives Audio's calibrated test cd that's designed to work with the Radio Shack SPL meter. It really helps to use a bit of calibration dialing these things in. Level, contour, phase controls, etc. don't always have effects that meet logical expectations.
Assuming you're running a powered sub, connected with RCA's.

I'd suggest using Rothwell 10db attenuators, which will allow you adjust the pot on the sub to a much more optimal setting.

I use this method with my Sunfire sub and it allows for a MUCH smoother intergration with my main speakers.

It really makes a HUGE difference.
You may be exciting room resonances that were not evident before. If the SW does not have its own equalization circuitry try a Behringer DEQ2496. The RS meter and Rives CD will set you back about $100. For $350 or less the Behringer will do a better and much easier job of showing you what your problem is, and after that it will fix the problems, which the RS meter will not do.