2. amps-preamps
  3. 1287979282

Is it ok to Bi-amp using different Brand/model of

amps or is it best to use the identical model for muliti-amping? I like to add another SS stereo amp, to get more snap, quickness, detail, and more power to the sound.

Currently I’m horizontally bi-amping my Hales Concept 5 speakers, which are a 3-way, with a pair of BAT VK-60s. One amp is driving the mid-tweeter (passive XO still being used here) section of the main speakers and the second VK-60 amp is directly powering the woofers. A Marchand active XO has the woofers set between 80-550Hz. A pair of self-powered sub-woofers handles below 80 hz.

The VK-60s can easily become monoblocs. As monoblocs, each amp will drive each speaker’s mid-tweeter section and a third amp, stereo, used to power the woofers.


On the BAT website, specifications for solid-state & tube amps such as; input sensitivity, frequency response, THD.... are all different. Will these differences in specs harm the sound if I were to join SS & valve amps together in the same system? Will timing and coherency be affected? Thank you for your inputs.
128x128norm
ngjockey
1,042 posts
 
Looks like you're getting covered technically. I can add is the quality of the level controls affects the amount of fiddling. When I first tried biamping with pots to control the more sensitive amp, I was constantly going back and forth. Upgraded to an attenuator and it was set and forget. Wouldn't worry about the Marchand.

Different amps is my favorite method. More complex to set up but it allows selecting the right amp for the specific job. Whether it's SS/tube or NFB/no NFB, or whatever criteria, there are different demands through the frequency/driver spectrum.
stewie
187 posts
 
My two cents: I've bi-amped using a 170 wpc ss power amp (with volume control; but an attenuator would work as well) on the bass cabinets, and a pair Dynaco 60 wpc monoblocs on the mids and highs. They're run through a Juicy music peach ii preamp, which has a setting for "low" impedence. Anyway, with the pots on the ss amp turned back to about 4, the set up sounds great from low volume to high. Best of both worlds, with the possibility of adjusting the bass/mid-treble ratio to taste with particular kinds of music.
rrog
1,958 posts
 
I agree with Racamuti. Since you are concerned about coherency, before introducing a solid state amplifier into the system I would try verticle biamping.
norm's avatar
norm OP
52 posts
 
Hi Ngjockey,

In my set-up the stock Marchand attenuators allows "set and forget".

Do have a preference as to class of power in amps, (i.e. Class A, AB, D, .....) when pairing up with tube amps?

Regards,

Norm
norm's avatar
norm OP
52 posts
 
Hi Rrog,

In my case, vertical bi-amping would mean two more monoblocs to achieve my goal. I may end up that way, but for now I like to stick with a stereo amp to lessen the number of chassis in the room. Thanks.

Regards,

Norm
More to discover