Isolation for power line conditioner?


I have heard that many gain good results by providing isolation for their PLC units and was wondering what type of suggestions/experience folks out there may offer. I do currently have my line conditioner (Sound Application XE12-S) on a slab of MDF on aluminum cones. I put this together awhile back for the PLC I had at the time, and chose this route simply cuz I had the stuff lying around and it seemed to be better than nothing. That aside, considering this particular unit is, I believe, primarily a passive component, what solutions and ideas can you throw my way? Thanks in advance!
centurymantra
OK, maybe substantial and significant, as far as the power conditioner go, are a bit strong. It's worth the $$, to me, for the upgrade in sound. Cdp and amp? there I'll go with substantial or significant. peace, warren
I have measured the effect of Sistrum under my cd player, amp and pre-amp..with a 1.5db increase in gain. I have a LGE power transformer in my side yard 30 ft. from my main breaker box..I have never found a line conditioner that did not screw up the sound of my system..However I have sold Sistrum to clients who have used them with their line conditioners and they have stated they heard a marked improvement. Tom...I represent Sistrum, when people try it they keep it.
I have been selling electronic test and measurement equipment for the better part of 15 years. I sell some of the worlds most sensitive, high dynamic range spectrum analyzers in the world with bandwidths from 10 Hz all the way up to millimeter wave frequencies. These analyzers have dynamic ranges of 145 dB and noise floors of -130db to -140db. These instruments sometimes find themselves in both production environments (notoriously poor environments)and metrology lab situations (controlled near perfect environment). It's funny, but these analyzers don't have pointed feet or special power cords or power conditioners and rarely see clean power yet they always meet spec and look as spectrally clean as if they were in a perfect environment. Why do you suppose that is? Could it be that all the tweeks are just compensating for poorly designed equipment?
Good analogy Stehno, but you're contradicting one of your earlier posts. Either "every component is near equally susceptible to capturing air-borne vibrations" or they're not. I see no logical reason to except cables. Even though I say it somewhat mockingly, why wouldn't a house's main electrical panel be susceptible to the same claimed improvements heard by isolating and/or mechanically grounding a power line conditioner. The electric panel is just as much in the music signal loop as is the power conditioner.

Am I the only one would finds Theaudiotweak's comment about the effect of Sistrum platforms on circuit gain as absurd? As audiophiles are we so desperate for performance improvements that we'll accept any claim, no matter how lacking in logical explanation, as potentially true?